new init.d governors and schedulers disappearing
Started by
smeekteek
, Feb 09 2013 02:09 PM
10 replies to this topic
#1
Posted 09 February 2013 - 02:09 PM
On every ROM I flash, the new governors and schedulers like "hotplugx" disappear after a while with no warning. I never alter the system files. Anyone have any ideas?
#3
Posted 10 February 2013 - 05:20 PM
ICS on maxx. I've tried just about all ROMs. It happens with all.
#4
Posted 10 February 2013 - 05:21 PM
Oh and ROM Toolbox Pro.
#5
Posted 10 February 2013 - 05:58 PM
Some ROMs will have the modules already in them, but read this for more information:
Perhaps the ROMs you have do not have the modules, I do not know as I have not looked into it. But have a read and see if that can help you Specifically:
echo [governorname] > /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
Perhaps the ROMs you have do not have the modules, I do not know as I have not looked into it. But have a read and see if that can help you Specifically:
echo [governorname] > /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
#6
Posted 12 February 2013 - 07:33 PM
Thanks for your help. I have not looked at your link yet but, for instance, I just flashed Revolution and 2 days the schedulers and governors are gone again.
#7
Posted 12 February 2013 - 07:38 PM
and pardon my naivety but i don't understand what that bottom line means.
#8
Posted 12 February 2013 - 10:27 PM
I also have noticed this on my jb rom with Rom Toolbox Pro. This started happening after the last app update. I now use No-frills CPU Control for that stuff.
Sent from my DROID RAZR using Tapatalk 2
Sent from my DROID RAZR using Tapatalk 2
#9
Posted 14 February 2013 - 10:09 AM
is part of the init.d script (normally named modules, or something like that) that will load the governor at boot (located in system/etc/init.d). Once you have a look at that link I posted it make make a little more sense. What does that mean for you? Well, if you add the above line to the modules script then it will load the governor on boot and it should fix your problem.
This is definitely more involved and more difficult than just setting it with an app. Think of it as "hard wiring" the governor. But it is more difficult to set up. I can give you more information if you need it.
#10
Posted 14 February 2013 - 10:56 PM
This time, I do believe it's just a problem with an app. I have been running Evolution for over three weeks and the governors were displaying just fine in Rom Toolbox Pro, until I updated the app about a week ago. I can still pick different governors and schedulers with Rom Toolbox, it just doesn't show them until I pick one. So I flashed JellyHaters into Rom slot 2 just to verify that it wasn't just a problem with the rom I was running. Low and behold, Rom Toolbox was at it again, but No-frills Cpu showed all of them.
Sent from my DROID RAZR using Tapatalk 2
Sent from my DROID RAZR using Tapatalk 2
Attached Files
#11
Posted 16 February 2013 - 08:01 AM
Moving to Droid Razr General [XT912]
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users