9 replies to this topic

[talha4prez]

I have downloaded as least 10 different roms in an attempt to test them all, but I can't seem to get any of them to stick except for CM10.1 Spyder. Not that I don't like it, but every other rom I attempt just seems to get stuck in a continuous boot loop. Is there anyone that can assist. I would love to get going on testing out some other roms. Here is a list of what I have attempted flashing so far with no success:

Agression
Eclipse 1.1
Fuzion_razr & HD RC1
Evolution JB 1.8.1
Jelly Haters V3
Jelly Wiz RLS7
Paragan Spartan 2.1
Fat Free Bean

O yeah, I have successfully rooted my Razr XT912 running 4.1.2, and installed safestrap 3.11, I just don't get why they wont flash correctly....any help will be appreciated.

[RikRong]

Are you doing full wipes each time you try to load a ROM into your custom slot?

[talha4prez]

Yup, wiped data/cache/delvik/system still nothing.

[aldriciv]

I'm in the same boat, I haven't tried nearly as many ROMS (only CM10 and Eclipse 1.1) but I still get stuck in a boot loop. I don't know if it helps or not, but it's not a ROM boot loop, it goes from the red circle M to safestrap, indefinitely.... ANY help would be much appreciated.

[Memnoch73]

Guys... You are trying to load Roms on the Xmas Kernel (.8)onto your OTA (.16) system. Use

Please Login or Register to see this Hidden Content

to change the kernel then your rom will load

[talha4prez]

Thanks I will definitely give it a try, and report back. Actually before I get moving on this one, should I run it while in stock rom slot or in one that I create?

[talha4prez]

Guys... You are trying to load Roms on the Xmas Kernel (.8)onto your OTA (.16) system. Use

Please Login or Register to see this Hidden Content

to change the kernel then your rom will load

I managed to get the JellyWiz rom working beautifully, however, in my stock slot I am getting a Security Test Failure please restart phone. I have restarted several times but no luck, I can no longer access my stock slot. Is there a way to fix this issue?

[talha4prez]

It's because you're not on the right kernel.

I figured that from reading one of the post in the compatibility thread, but I can't figure out how to switch it back. I ran #2 in the file to set up the original kernel I had but it does nothing. I thought this was going to allow us to switch back and forth at will, Is there anything I can do to switch it back so that I can use my stock slot again?

[talha4prez]

Got it, looks like I wasn't following directions..thnx for the help guys.